PRINTING
1. Mirror the image.
2. Load the paper so that the image will appear on the coated side.
3. Paper should be fed into the copier or printer with the short dimension first ( grain long)
4. Start with “plain paper” mode. Adjust to a heavier paper setting if necessary. Do not over saturated paper.
5. There is no need to trim away the unprinted areas of the transfer.

Transferring Using A Commercial Heat Press
1. Place the transfer sheet face down on the substrate and press 25-30 sec. At 375f-400f using med. Pressure.
2. Can be peeled hot or cold

Washing Instructions
Turn garment inside out and wash in cold water using a mild detergent. Don not use bleach. Dry on low heat setting. May be ironed on the transferred area.

Storage and handling of Soft Jet Light Heat Transfer Papers.
Store in a cool, dry area and do not remove from carton or poly bag until you are ready to use.

IMPORTANT:

We thoroughly test each of our products on various substrates using different transfer equipment. However, it is impossible for us to duplicate all variables using all substrates and transfer equipment. Therefore, it is essential that you test the paper prior to production using you equipment, methods, and substrate material. Heat presses vary in accuracy. Conduct test to determine the best time and temperature to use with your equipment. Please keep in mind that the seller’s and Manufacturer’s maximum obligation shall be to replace any paper that is proven to be defective. Neither the seller nor the Manufacturer shall be liable for any injury, direct or consequential, arising out of the use of, or inability to use this paper.

CREATIVE TRANSFERS, LLC
800/721-5144
E-MAIL:creativetrans@bellsouth.net
Soft Jet Light Heat Transfer Paper
For Ink Jet Printers.
(Blue Back)
USING A HAND IRON

Using a home iron

1. Preheat iron to highest setting for 5 minutes. Do not use steam. (Empty all water).
2. Iron on a very smooth hard surface that is waist level or below. Do not use an ironing board. Place a pillowcase on the surface and iron the pillowcase to remove any wrinkles.
3. Put the garment o the center of the pillowcase and iron it to remove any wrinkles.
4. Place the transfer with the image side down in the center of the garment with the ironing sheet on top.

Full Sheet Transfer

1. Using 2 hands and firm pressure, slide the iron up and down. In 90 seconds, make enough passes to completely iron the shirt 2 times. The iron should be halfway off the edge when the edges are ironed.
2. Using 2 hands, firmly slide the iron side to side. In 90 seconds, make enough passes to completely iron the shirt 2 times including all edges. The iron should be halfway off the edge when the edges are ironed.
3. For smaller transfers of one half sheet or less, the ironing time is reduced to 1.5 minutes total. If transfer areas is smaller the iron, iron for 30 seconds with heavy pressure.

Paper Removal

May be peeled hot or cold.

To see all sizes and to order go to: INKJET SOFT JET LIGHT

or Buy and try a sample of this product first-CLICK HERE

HOME

CONTACT US

ABOUT US

POLICIES

VIEW CART

HEAT TRANSFER VINYL - LETTERS/ NUMBERS/ DECO
INKJET ADHESIVE BACKED VINYL
INKJET PHOTOGRAPHIC PAPER
INK SYSTEMS
OKIDATA LASER PRINTERS
PLOTTER CUTTER
SIGN VINYL
SILK SCREEN CLEAR FILM--POSITIVES
HEAT PRESSES

BLANK MOUSE PADS
DAZZLE TRANS
SAMPLE PACKS
TRANSFER PAPER ,
HEAT TRANSFER PAPER,
HEAT TRANSFER VINYLl,
LASER TRANSFER PAPER,
INKJET HEAT TRANSFER PAPER,
IRON ON TRANSFER PAPER.