INK JET (OPAQUE) TRANSFER PAPER (ONE STEP)

INSTRUCTIONS:           DO NOT MIRROR IMAGE
                               COLD PEEL
                               For Ink Jet Printers Only
                               Designed for Commercial Heat Press

SETTINGS:                    Set Heat Press at 350 Degrees

APPLICATION:

1. After the image transfer is completely dry, trim the image, you will
    have to trim into the edge of the photo so the white will not show.

2. Holding the paper on one side corner between your two thumbs, pull
   the corner outwards, the film will stretch and the paper will tear,
   then slowly and smoothly peel off backing.  When you do this a few
   times it will get easier, have patience.

3. Position image face up (imaged side) up on the garment, smooth
   out the image film and place SILICONE SHEET over the image.
   Make sure the whole image is covered. If you want a glossy look
   to your image place the backing sheet (blue grid imaged) shiny
   side down on the imaged transfer, rather than the silicone sheet.
   The silicone sheet can be reused several times until it gets brown.

4. Place the imaged transfer onto garment face side up, place the
   silicone sheet on top and press for 20 seconds and let the silicone
   paper cool before peeling.

COTTON/ COTTON BLENDS----375 DEGRESS
(HEAVY PRESSURE)---20 SECONDS

SYNTHETIC FABRICS----350 DEGRESS
(HEAVY PRESSURE)-----25 SECONDS

WASHING AND DRYING:
It is best to wait 24 hrs. before using or washing for the first time.
Wash inside out in cold water using a mild detergent and NO BLEACH.
Remove immediately from the spin cycle of the washer and dry, do
not let it sit.

If you use CREATIVE TRANSFER Pigment Inks there is no washing or dry
 problems.

***After washing we recommend turning your shirt inside out and iron
the image from the back.